View Cart “GoPiGo Sensor Mounts / GrovePi Sensor Mounts” has been added to your cart.
Gertbot controller
NO HIDDEN FEES
With no Credit Card processing fees and shipping rates at standard Australia Post prices, you'd be mad to buy anywhere else.

ZERO RISK RETURNS POLICY
If within 7 days you don’t want your Raspberry Pi Supplies, we will not only give you a full refund, but we even pay return shipping!! Click here for details  

GertBot Robotics Board for the Raspberry Pi 3 or Raspberry Pi 2

Quick Overview

The Gertbot is a motor/power controller board for the Raspberry-Pi. The strength of the board is that it has its own CPU which frees up the Raspberry-Pi from a lot of intense computations and will take care of all the real time requirements. All you have to do is give it high level commands. Like: Board 2, Motor 1, take 2432 steps at 67 Hz. Even giving those commands is done for you using the free GUI which comes with it!

Out of stock

$89.95

Availability: Out of stock

Product Description

 

Hardware features:

  • Four H-bridges 8V-30V, 2.5A.
  • Bridges can be re-configured for 2x 5A or 1x 10A.
  • Two open drain outputs 30V, 3A.
  • Powerful 64MHZ ARM Cortex-M3 processor
  • RS232 connects direct to the Raspberry-Pi or other serial interface.
  • Cascade port to control up to four boards at a time.
  • 20-pin connector programmable for:
    • Automatic motor end-stop
    • Four 12-Bit ADC ports
    • Two 12-bit DAC ports
    • 8-16 general purpose

I/O Software controllable features:

  • Brushed1 motors:
    • Control direction
    • Speed control PWM 10Hz-10KHz, 0-100%.
    • Soft start 0.1sec
    • 5 seconds prevents in-rush current
    • Stop on switch hit.
  • Stepper motors:
    • Take X-steps in either direction o
    • Step speed 0.06 Hz .. 5KHz.
    • Stop on switch hit.
  • Digital Command Control (model train control):
    • Can send any DCC command 3..6 bytes
    • Programmable pre-amble length and repeat count
  • Short-circuit or high temperature error detection
  • On error, keep running, stop motor, stop board or stop all boards
  • I/O pins programmable functions
  • Emergency stop, halts whole system.

The board comes with drivers, example code and a GUI all complete with source code. Depending how fast you can screw the wires down, you can have your motors running in a few minutes!

Additional Information

Weight 100 g